Battery Level Indicator:
The battery capacity is displayed via green, yellow and red LED lights.
Green = Almost fully Charged. When the iTaste VV4 is fully recharged the LED light will power off.
Yellow = Half Power.
Red = Low Power. Charge the VV4.
Voltage can be adjusted from 3.0 – 6.0 volts in .1 volt increments.
Wattage can be adjusted from 6.0 – 15.0 Watts in .5 watts increments.
Large battery capacity:
The iTaste VV4 e cigarette has a built-in 1000 mAh polymer Li-Ion rechargeable battery.
ON/OFF battery switch:
Press the power button three times in rapid succession to turn on the iTaste VV4. Once the vaporizer is On hold down the power button to activate the atomizer and vape. When the iTaste VV4 is not in use, press the power button three times in succession to power off the iTaste VV4 Advanced Personal Vaporizer. Always power off the iTaste VV4 Advanced Personal Vaporizer when it is not being used, or when it is going to be stored in a pocket, bag or purse.
* 10 second cutoff: If the activation button is held for 10 seconds or longer the iTaste VV4 Advanced Personal Vaporizer will stop firing until the button is released and pressed again.
* Low Voltage Warning: The Red LED and Battery bar will continue blinking when the battery capacity is lower than 3.3V and the Advanced Personal Vaporizer will power off automatically.
* Short Circuit/Atomizer Protection: Short Circuit/Atomizer Protection protects the Advanced Personal Vaporizer against shorted atomizers and will stop the unit from functioning in unsafe conditions.
* The iTaste VV4 features automatic real-time atomizer Ohms detection. If the resistance of the atomizer is lower than 0.8 the Ohms bar will blink.
* If there is a short circuit the VV4 screen will display the following and the LED light will power off.
* Over-Discharge Protection:The Advanced Personal Vaporizer monitors the battery voltage and will automatically power off when the battery is discharged.
* High compatibility 510/ego connector: Threads are compatible with the following clearomizers: iClear16, iClear16B, iClear16D, iClear30, iClear30B,iClear30s, iClearX.I. Gladius and other standard 510 threading.
- Variable Voltage: Voltage can be adjusted from 3.0 – 6.0 volts in .1 volt increments.
- Variable Wattage: Wattage can be adjusted from 6.0 – 15.0 Watts in .5 watts increments.
- Standby current: 50uA max
- Maximum output current：4.0A
- Charging: Micro USB DC5.0V/500mA
- Short Circuit Protection: 0.8 Ohm